Tenergy Smart Universal Charger for NiMH / NiCd Battery pack 7.2V – 12V with charging current Selection/Temperature Sensor

Accessories Included

1 standard Tamiya connector.

1 connector adapter from Standard to Mini Tamiya.

1 set of alligator clip adapter with standard Tamiya connector on one end.

1 Temperature sensor

Specification

Input: AC100-240V

Output: 7.2-12V 0.9or1.8A

Operation Instruction

Connect battery pack to output connector and plug AC power source

Make sure battery polarity is connected correctly (Red wire is positive)

Charger will detect battery voltage automatically, Red LED will be on during charging

When battery is fully charged, current will reduce to trickle charging at 50mA, Green LED will be on

Approximate Charging time is about 1.5hrs for 3000mAh battery,1hr for 1800mAh battery

Battery pack capacity should be 900mAh or higher

Please contact your seller for instruction. Mfg is not responsible for any damage and consequent damage by Misusage

Caution

The charger is designed for indoor use only. Don’t leave the charger unattended during charging

The charger should be positioned horizontally and in well ventilated condition, avoid water and keep away from flammable/explosive goods

Don’t cover the charger when charging, ambient temperature shall not be more than 40oC

Don’t leave the batteries and chargers on wood surface/carpet

Cut off the power supply before connect/disconnect the charger with batteries

Don’t disassemble the charger, High voltage inside!

WARNING – DO NOT CHARGE LiPO BATTERIES

-DO NOT CHARGE: if the label on your battery says: LiPO, LIPO, Li-Po, LI-PO, Li-Polymer, Li-Poly, Lithium Polymer, Li-ion, Lithium-Ion, Lithium

-Caution: LiPO battery packs may often have two sets of leads/connectors – do not charge if identified as LiPO battery

**Failure to follow these warnings may result in fire or personal injury

Contact our customer support team if you are unsure if your battery can be charged